Club 80-90 Forums

baj25 wrote:Get a bilge pump? ☺

Lol I think its coming in from the seam on the arch

Hi just wondering if it's just the rear window seal leaking or could it be leaking through the rusty seam? I found about 3" of water inside the rear panel today. Has any one got any advice cheers

itchyfeet wrote:Check tge dizzy vac advance unit works, it should be seen moving the rotor arm when you suck on the pipe, you do have to suck hard.
then stop revving the nuts off it stationary

Thanks I will try that.

It's has a standard rotor arm. I'm going to repair the exhaust and then check the timing,and then check it again.

I had a run in the bus today,and it seems to run fine but it does puzzle me why it will not run on full revs when stationary.

Cheers I will check the timing and take it for a run. Thanks for your help. I will let you all know how I got on tomorrow.

This problem is when stationary, as it has no mot at the moment. You can see the second choke open when on full throttle.

It's the round one.

Hi can anyone help? I have a 1988 bus , the problem I have is when I start the engine it runs fine but if you open it up to full throttle, it's sounds like it is not getting enough fuel but if you look down the second choke the fuel is spraying in from the lower jet and top jet, may be little to muc...

Hi can anyone help? I have a 1988 bus , the problem I have is when I start the engine it runs fine but if you open it up to full throttle, it's sounds like it is not getting enough fuel but if you look down the second choke the fuel is spraying in from the lower jet and top jet, may be little to muc...

Hi I was just wondering if anyone has ever fitted heavy duty 8 ply tyres to their bus? They are normally used on vans which are carrying a lot of weight,so I don't know whether this will affect the ride or noise. Does any one have any thoughts on this? Cheers Umm, your van SHOULD have commercial-ra...

Hi I was just wondering if anyone has ever fitted heavy duty 8 ply tyres to their bus?
They are normally used on vans which are carrying a lot of weight,so I don't know whether this will affect the ride or noise. Does any one have any thoughts on this? Cheers