Club 80-90 Forums

Hi Ghost
Its a 2.1 injection

Hi Chaps I have a 2.1 Crew Cab, i used it this weekend to drive to Wales, all was fine on the way down no issues whatsoever. On the way back i got stuck in three different traffic jams(lucky me). After crawling along at no more than 10mph maximum the van started to get very lumpy, a few times it cut...

Hey Elvis
My old dash was a non rev counter so the fuel gauge is different, whats a pcb ? My old gauge worked fine once i put my old dash back

thanks for the hasty reply mate much appreciated

Andy

Hi Guys I have recently managed to get hold of a rev counter T3 dash for my crewie, i plugged it in today to see if the post 86 vans had the wiring already in place for the rev counter like a lot of people have said already, and to my surprise the rev counter worked straight away, what didn't work h...

Hi Again Guys Just to follow up on this issue, i got in the van this morning to drive to work at 5 am it was cold ish, i drove about 3 miles along 30mph roads sat at one set of traffic lights all in all around ten minutes in the van i guess and the temp warning light started flashing red, i turned o...

Hi Guys Thanks for the speedy replies, firstly it was a typo, what i meant was that before any of this work was started the temp needle used to sit bang in the middle, now since the work has been carried out the needle sits more at a 1 o'"cock" position just to the right of the bulb. I ret...

Hi Guys New to the forum and this is my first post, I have a 1998 2.1 dj crew cab, i had the dreaded red light flashing on temp gauge and had some work done to replace the thermostat, after that work the temp gauge stopped working, the guy doing the work told me there was a part in the thermostat no...