Club 80-90 Forums

Anyone tell me if inside vwt25 1982 watercooled diesel 5 speed should have at gearstick base a slope plate or early flat plate i know that early air cooled had slope plate away from driver but not sure about water cooled also at the rear which vans used the bellows .i tryed today pushing a set into ...

Anyone tell me the right way for front and back of 5 speed vwt25 rhd Gear selection.reverse is over to left front,bringing selector arm at rear fully out right back.etc anyone run me through all the gear sequence front and rear as My van was set up as 4 speed at front but I since have found that it ...

Thanks for the replys .i took right rear wheel of today the studs are longer indeed welded on inside of hubs . Hub back on then there's a plate which sits on outside ,then steel wheel.think this adapter plate is indeed to do with alloys.i took it out put wheel and tyre on against hub as should Be.th...

My problem is my t25 rear wheel studs are long with no thread near hub end.there is a plate behind steel wheel on top of hub then round spacers then nuts.my wheels are sitting funny.stupid question but does standard steel wheel go direct onto hub as I think someone has adapter plates on them but are...

My problem is if I put a pair of vice grips on to gear selector arm on gearbox,pull arm out and push forward my reverse beeper comes on,if I pull selector out and push back the reverse beeper does not come on.to my knowledge this means it is selecting reverse for a 4 speed set up but has a 5 speed g...