Club 80-90 Forums

Hi All, As per my previous post - bought an Eberspacher d2 off auction site which was sold as untested - I can get it to go through the motions, starts, fan accelerates etc, glow plug gets hot but after the set time it refuses to put power to the diesel pump. Checked the pump separately which pulses...

Top man - thanks

Hi, Partial success ! When I short out the yellow wire it activates the fan after a few seconds delay. This runs and speeds up but the diesel pump doesn't kick in - checked if there is volts getting to the pump and nothing seems to getting to the pump after 20 secs or so of running - pump is connect...

Pm sent

Weird ! With the Earth disconnected from the brown / white wire (and the rest of the wiring as before) the green lamp is now still illuminated when in the off position. Checked 12v is OK to heater on +ve and -ve but no voltage from yellow from controller when either off ( with green light on ) or on...

Hi,

Sorry to be a pain but I've got the technical and workshop manuals but can't see procedures on page 25 and 26 - you wouldn't have the list would you - cheers

Steve

Hi, I'm confused now ?? I did as you said and grounded the brown/white wire and connected all the others as per our previous correspondence and now I get a green light illuminated on the rotary rheostat when it is in the clicked off position - when I turn it clockwise it clicks and the green light g...

Hi Will try grounding those wires - with everything connected I assume I'm supposed to have light illuminated in the middle of the rotary switch but it isn't ?? Yes the brown/White is connected from term 1 on the controller to term 6 on the heater and red / green is connected from term 2 on controll...

Hi

Ive got the thermostat rotary knob controller
Connected Red +ve to 5, Yellow to 6 and -ve Brown to 3 on rotary controller

On the Eber I've connected Red + ve to 1, yellow to 4 and -ve brown to 10

I've done pics but they are too big.... Will try in a bit

Thanks
Steve

Hi

Thanks for yr reply - only just bought it used off eBay and trying to get it to fire up -

Connected +ve to term 1 and Earth to term 10 and attached trigger yellow term 4 but nothing
Do I have to leave it a while ?

Ta
Steve

Hi All, Just wondered if there were any Eber experts out there that can help. My Airtronic d2 won't start - when it gets a signal to fire up from the yellow wire it will click only once - continued attempts to fire don't give anymore clicking. when you take power off the main unit it clicks again - ...

Hi All, No slime in the tyres lol - seen that before tho Actually front to back change did make it less of a problem but still there ? May get tracking checked out .....I meant to mention I have 16" merc ml alloys all around but have Brickwerks spacers on the front to clear the top wishbone ? W...

Hi All, I'm trying to eliminate front wheel wobble that occurs about 55 - 65 mph I've had the wheels balanced without success - bit of an odd one as it only happens sporadically and not all the time - sometimes it can be smooth as silk then it builds up and can get quite bad - then disappears again....

Key Diesel - Burton on Trent

Apparently the timing was a little bit advanced - even though the timing marks (TDC - fuel pump - camshaft) were bob on, the pump needed fine tuning They used a dti gauge and measured and tightened every thing again and again until it was just right. Just a slight margin out makes a big difference T...