Club 80-90 Forums

I've checked them all and ok but will change it to make sure

Hi just need a bit of help hazards not working on my 1990 1.9 petrol van indicators working so thinking the hazard switch has gone . The problem is I can't seem to find a switch with the extra spade conector on does this matter and is it only to light it up .Thanks.

Thanks for that just a quick question though someone told me that the shims shouldn't go is this true .If so should I be worried that something major is wrong.

Hi just need a bit of advice been doing the crankshaft il seal and when I got it out the end float shims have had it so gonna replace . I know you need three but to make certain measurement but what are best sizes to get as the price of them seem to be about a tenner each so don't want to get ones I...

No its not with it been cold it can start up fine and then after driving down road it starts revving fast and I mean really fast. No one has touched carb my wife uses van as a daily ride and it has just started happening when it happens if you turn van off and turn it over again it's fine and then h...

If its the choke not opening is it easy to sort .. cheers

Hi has any ideas what's wrong with my van 1.9 petrol I can start the van and it idles fine but after a bit of driving it starts idling really fast .sometimes when I start it its over revving but then fine after a bit and so on.any ideas would be appreciated.

Hi wanting to put some alloys on my 1990 hi top but want something that will go straight on without spaces and new studs so my old spare will fit if needed.

Is that in the handle it's self then or in the workings in the door card

No key not moving at all when I bought van it was a bit temperamentall then at some point just stopped working put knob inside van lifts up and down fine by hand when door is shut

Tried wd but no joy

Hello anyone any ideas on my drivers door lock it won't open with key I can pull the knob up from inside though. Cheers

Hi just changed crank shaft oil seal and changed the o ring put it all back together and still leaking. Guessing I damaged seal putting it in just wondered if there is defiantly only one seal and o ring. Cheers

Hi crank shaft oil seal has gone so gonna change it and do the clutch at same time just wondered how bad of job it is and do I need to drop the engine or can I do it without dropping it. Cheers

Thanks for that will have a look in morning