Club 80-90 Forums

Hi,
Can you tell me if this gasket requires sealant. I am assuming no, but wanted to ask the experts. Planning on creating a new one from scratch as they are difficult to get in Australia. I am assuming they are made from the standard cork/rubber gasket compound?

Cheers
Hally

Thanks Aidan, much appreciated....one for the wiki perhaps.

Hi,
I have a 1989 2.1 Auto Caravelle 7 Seater. Just got it the other week. Needs a few bits and pieces. It needs new disks and pads to pass the Road Worthy (MOT). It has ABS brakes. Are the disks and wheel bearings different to non ABS brake models?

Cheers
Hally

Well there you go. I am obviously going blind..... Thanks I'll take a closer look tonight. and get my hands on a lambda sensor....If I recall correctly this was replaced by the previous owner cutting wires.....Although I thought I had sorted this when I went over the whole loom repairing dodgy conne...

Thanks for the replies everyone. Some further information. Driving into work this morning to pickup the Chrissy ham and it was raining again. Only lightly this time. Everything appeared to be ok. Until the rain got heavier and the road was wet. So I am guessing something underneath is giving me grie...

Hi everyone, yet another question. To those who wondered about my headlights... Yep it was the ignition switch Finally down here we have had some decent rain (although we still only have 34% in our water catchments). The strangest thing occurred to me. I did have this happen about 12 months ago repl...

I gotta me me one of those. Very sweet.

Hmm can't login to wiki to add it in, bummer

There you go....Ignition switch. So the test is check voltage on black/yellow for 12v in the run position. If nothing then kiss your ignition switch for a replacement. Now off to pull it out and put everything back to gether. Thank you All hail the X circuit explainer Synchro-G. Come to Oz and that'...

Glen, Than explination is worth a sticky or a wicky! Thanks. I'm going to check this out shortly. As far as the immob goes it cuts into the starter power and the fuel pump. it also has a connection to ignition, ground, batt 12v and supposedly parking lights (that's the manual, but wiring says differ...

Well if the $ gets down to the levels they say it will. There will be a lot of very cheap holidays here....That's if you have GBP to spend....

I'll take another look tonight and hope that the ignition switch I orderd turns up.

Cheers
Hally

Hi everyone, After a long while I'm posting again.....Anyway down here in Australia I've got a 1989 2.1 Sunliner conversion. Driving home late the other night Main Beams decided to give up the ghost.. Symptoms - No main beam - No Heater fan - High beams turn on when you hold the flash lever but do n...

I've done the rear window twice (glass). Was a fairly straight forward job when I did it. I believe the key is to push it from the inside out to remove. I used some Cat 5 cable and stuck it under the lip of the seal to help. Replacement was the reverse process, but I had to use a little persuasion f...