Club 80-90 Forums

What work do you need doing?

1.9 flat four

I would like to add two a additional gushes to the dash. Water temp and oil pressure. However, looking round the engine tonight there doesn't seem to be an obvious place to mount thd additional sensors. Has anyone done this before? If so what route did you take?

Cool, thanks

OK I've gone for a 3.5V LED with a 47Ohm resistor

I need to replace the indicator, main beam LED's etc, I've searched on the forum but I can't find what voltage they are. They don't seem to be 12V

Now this was a pain to fit

Does anyone know if it's OK to weld up arms for an MOT, mine has a little rot

Also the edge of the passenger seat would be visible if it were fitted

open the passenger door and look towards the bottom of the b pillar, the whole is where the seatbelt mount would be.

Thanks shepster!

I was just starting a repair to the passenger side seat belt mount as it was rotten, soon to discover so was most of that area, no surprise there. However, I found a plastic bottle under that arch, it has a single pipe into the top, and two out the bottom. Any ideas what its for? There doesn't seem ...