Club 80-90 Forums

yes and yes

more top work mm

hope you don't mind me asking, are the pins you have used in the pic below the aviation pin thingys? what are they actually called? where did you get them/where can i get some from?




thanks, billy

you could try here:

http://www.vwbusshop.de/

you could try here:

http://www.vwbusshop.de/

looking into the options for our van does anyone know how many metres of fabric/vinyl would be needed to retrim two front seats, 3/4 length r&r bed cushions, and the roof bed cushions in a camper van? and if anyone has done a complete interior retrim including the above and all doors cards, how ...

i agree with KNT - get some good pics up - where are you spraying, what are the conditions like? most likely causes are not cleaning the surfaces well enough before laying primer or paint (small amounts of contamination from sanding water or sweaty hands), not allowing enough time for evaporation be...

hey bbs, looking

don't forget to add a write up and some piccies of the headlight mod

loving what you're doing

hello there, i'm new to t25s myself, but i've been around vw's for enough years to put a dent in my kids inheritance :lol: i have the same roof and the same hinges fitted to my van. here are my thoughts about what i would do if i were you: first off, get the ripped/rusted hole in the roof repaired p...

In the end it turned out to be number three spark plug giving up the ghost. but have you established the cause of the failed plug? get a compression test taken sooner rather than later, esp. on number 3, and check your valve adjustment - if it's a new (to you) van, don't assume the hydraulic lifter...

hello devonboy and welcome :ok from what you have described i would suggest you start with/check the obvious things first it's intersting that your mechanic went straight for one of the less likely, but more expensive, options - i'd be going somewhere different in the future if i were you :wink: hav...

if it's a double/dual advanced dizzy, then you should need to set it at 5 degrees after top dead centre (atdc) the timing marks should be visable on the rear of the fan housing (ignore anything on the front if you're not sure they are copies of the marks on the rear) if you can't find the marks on t...

do you mean this one? (not cheap)

http://shop.volkswarenhaus.de/product_i ... us-T3.html

could try soda blasting with a compressor then rinse off with a pressure washer. the soda won't damage anything, just be careful where you're spraying it if the engine is in situ, wrap up carbs, etc. first. i use it for cleaning up engine cases, cylinder heads, carbs, etc. when rebuilding. it gets e...

yes i do mike, but it wasn't obvious from the part of the thread i read and pics i looked at that it is a panel conversion it was obvious the guy doesn't have much tin bashing experience so i thought i'd offer an easier alternative option for him to consider i have done a bit of bashing over the yea...

the van pictured has windows