Club 80-90 Forums

hi guys sorry to jump on the post but I have same problem, ive just bridged spades as lloydy said and bingo,brake lights came on,i have two switches,are they both the same and should I change them both ?,replies ,advice appreciated,thanks Laurence.

hi guys ive just purchased two new felt seals for my drivers door,are these supposed to stop all water going inside the door ?, fitted them and they aren't really tight to the glass and rainwater still dripping down inside the door, 4 clips inside the door for each seal,is that enough?,thanks Lauren...

hi guys ive just purchased two new felt seals for my drivers door,are these supposed to stop all water going inside the door ?, fitted them and they aren't really tight to the glass and rainwater still dripping down inside the door, 4 clips inside the door for each seal,is that enough?,thanks Lauren...

hi, would somebody with the same engine as mine, 1.9td aaz , please check which way there wires are to the oil pressure switches, yellow to the head and blue to the oil filter flange is what I have, thanks. while im here do any of these numbers relate to my engine number, 028103373j,,,8wwo,,,28k93,,...

hi, ive had a look at the pcb before but will check it again tomorrow, ive used the discount code with ecp today and got some engine flush and 10w40 semi synth/new filter as at the moment its got 15w40 mineral so I will give that a go as well,thanks laurence

hi, quick update, I grounded the blue wire which meant the oil light is flashing constantly, driving for about 10 minutes the buzzer starts, so I pulled over and unplugged the yellow wire, (no switches connected now) light and buzzer still going off, took the blue wire off the earth connection, no w...

hi guys, been looking at this site, vincewaldon.com , on the page where it says how to diagnose dynamic oil pressure warning system further down the page there is a summary table, it shows the yellow wire to the oil filter flange and the blue to the cylinder head, on my engine the wires are blue to ...

hi mark, thanks for the info, much appreciated, Laurence.

hi mark, on the road last night and the buzzer went off again, I will try the 1.4 switch and see how that goes, also I asked in a garage and they asked what oil i was using, told them 15w40 mineral, they looked on there computer for my engine, 1.9td aaz, he said I had the wrong oil, should be 10w40 ...

hi all, so I did an oil pressure test today, from cold start the gauge showed 6 bar/85 psi,got it up to running temp/idling it showed a fraction under 1 bar/12 psi, then at 2000 rpm it was 2 bar, your thoughts/comments on these figures please,thanks Laurence.

hi rsxsr,i got two new switches from brikies,white and blue for my aaz,been ok for last few days but still gonna do a pressure test,starter motor went yesterday so had to get that refurbed,dont you just luv these vans, .

hi rsxsr,driving today and all ok,i wont be disabling any alarms till ive sorted this out,you say switches have different pressure ratings,would you or anyone reading this know the ratings for the white and blue switches on my 1.9td engine,ive looked in manuals etc but cant find this to verify my sw...

hi,ive been driving around for quite a few miles since last post no problems,then yesterday the buzzer and light came back on,keep checking engine and all seems ok,1.9td aaz,ive searched/looked for oil pressure relief valve,does my engine have one and if so where is it ?,thanks Laurence.

hi guys,thanks for your replies,this is weird as this afternoon I drove the van for about ten miles and no warning light or buzzer came on,i will try your recommendations and let you know how I get on,cheers Laurence.

hi all,sorry but my head is spinning,been thru wiki,manuals,web search regards BUZZER OF DOOM,1.9td aaz , started last week,oil light and buzzer came on,(engine upto to temp),pulled over,ignition off,started up a few minutes later and all ok rest of day,in the days following it became more frequent,...