Club 80-90 Forums

Actually I just read the Brixkworks info. Mine is a factory microbus bus, shouldn't it have the mounting points??

Thanks for replies!

It's a SA microbus and I've had the liner off and there are not mounting points.

I need some proper 3 point belts installed in the back. Can anyone recommend someone? I'm sure I've heard someone mentioned in one of the mags but can't think of anyone at the moment.

Thanks
Shane

Thanks Nindy

The HT leads are less than a year old as are the plugs. I'll have a look over the things you mention. This dizzy did burn up a rotor arm about a year ago, so I suppose I should look there. For some reason I was thinking it might be related to coil but now seems unlikely.

Need to try and get it sorted today if poss-especially if I need to get parts.

OK, it's been acting a bit weird for a few outings. Starts perfectly strong on the button. Leave to idle, runs for a few mins warming up and then quits. Get it going again and on the move quits every couple of mins requiring a restart. Yesterday when this happened on the way to work I pulled over lo...

Can anyone tell me the name of this part so I can do some ringing round?

Thanks.

Well, still struggling with this problem. I have located the clamp point at the side and it works to hold the 'box still but I still can't get the end of the rubber 'elbow' the sercure properly around the flange on the box. I'm wondering if I should try to find another one? Any ideas of where I migh...

Below the airbox there are 2 hole with rubber grommets which pegs in the bottom of the lower filter housing locate into. The clip on the upper housing then fastens onto the clip below the hatch opening ..... this can be pushed back out of sight. Once the housings firmly in place the majority of the...

tonytech wrote:Thats the same airbox I posted.
you can clearly see the clamp on the top right side of the airbox.

T

Sorry mate, didn't recognise it without the AFM on it.

It's the join indicated here... Rubber hose to metal flange on the air flow meter...

Found a pic on t'net! This is it...



I can now see how it clamps to the body but atill, the hose clamp issue?

Thanks for that Tony but my box looks nothing like that, it's oval shaped. There's no pic of it in the Haynes either:?:

Sorry yes, 2.1 DJ.

Right there is nothing at all there to secure the box. Not sure about a peg but I do recall seeing a hole with a rubber grommet in it around there. Deffo no strap of any kind present. Been looking for a picture everywhere on the net and can't find one.

Right, all my probs with our T25 seem to be down to a vacuum issue caused by a leak where the big rubber hose enters the air fflow meter from the engine side. Now, both pieces of the equation are in perfect nick, the hose and the flange on the AFM. The problem is that when I try to tighten the hose ...