Club 80-90 Forums

I seem to have sorted it! I accidentally pulled the wire off of the ignitor box that goes to the electrode and it started clicking! When I put it back it stopped! It seems if you put the terminal witching a few millimetres it will jump to the wire and then spark at the other end!! Don't really under...

its not a westy, we have a zig panel in the back. ive got 12v+ there and 12v ish at the switch on the fridge

That's what I thought but wasn't sure!

Forgot!

also, when I tipped it on its side to check things, liquid came out from inside. I think it was most probably the condensation catcher under the cooling element, but I'm worried it may be the fluid from the refrigerant?

Just revisiting this thread as we are still having problems. as we have had 240v for the last few holidays it hasn't been a problem. On the advice of on member I replaced the regulator as we had noticed a reduced power on the cooker. On testing with the fridge, it lit and ran well. :P We tested it a...

As far as I know the gas is ok, new bottle, same regulator as we had before the problem. Is there a way to check or test the thermocouple?

Yeah, even with it held it goes straight out and then there's no spark to give it another go

It's a brand new bottle

It doesn't light, just flashes a blue flame momentarily. Which bit is the thermocouple and how do I test it ?

ours is fused through the zig unit and I have checked all that out.

We have an electrolux rm123e fridge in our van. It has always worked well on all three functions, gas, 12v and 240v. We haven't used it since October and so I thought I'd test it out before the weekend. It wouldn't light on gas. When the switch was on it wouldn't spark. I removed the fridge and clea...

Both the rotor and cap are new, I will check the misfire with a strobe at the weekend.

Just revisiting this today as It hasn't really improved. Today I checked and replaced the plugs (NGK BP6ET), inspected the leads, all seem ok and have only covered 2000 miles or so, I'm not sure which cylinder has the misfire as its so brief I cant seem to pinpoint it. It seems to go through a perio...

Are you set on using melamine? have you thought about stronger and lighter altenatives like ply I'm really after whatever is cheapest, but it needs to have the high resistant 'plastic' finish. It's a shame you don't live near Grimsby: http://www.ebay.co.uk/itm/201220239709?_trksid=p2055119.m1438.l2...

Thanks, had a look and each board would be £105 which is way over our budget as we would probably need a few sheets.