Club 80-90 Forums

Great ! thanks

Sarran 1955, they were good you tube threads, Can you help with mine, ? I dont have the kit that you have though, I haved balanced the carbs using a crypton type gauge, I have a vac gauge, showing 200 at 3400 rpm what did you set the throttle plates to ? am I wasting my time with out a CO gauge ? Th...

too much fuel can cause the same simptoms as fuel starvation ? on the CU engine ( which I have ) I checked the following in this order, vacum leaks in inlets, and all hoses, check all wires timing 5 degrees after TDC with vac hoses on and idle stabiliser disconnected and plugged together this is at ...

have you adjusted the rear shoes out each side till they touch the drums then back off a bit till no friction can be felt when spinning with the wheel on and jacked up ? loosen the handbrake cable off first then adjust to 3 clicks after, ?

tick over IS slow on my CU engine, reversing in a car park, etc, can make mine stall, but mines an auto so cant rev it up and use the clutch,