Club 80-90 Forums

No kev..... I'm grasping at the easy solution until I can lift the lid lol!
she is in good condition , and I drive it with a light foot, so I am hoping its an easy job rather than surgery.
den

caps and leads sounds good.

will get to look asap and keep everyone updated.
den

hi guys vans last service was approx oct last year. the problem is definately NOT brakes binding/clutch slipping etc. This feels like it is only running on 3 cylinders which gives it the feeling of retarded ignition when accelerator is pressed and power is needed. : :( and of course on tick over it ...

would invite anyones thoughts
den

Hi everyone. been for a run out today easter monday. after a short distance, I noticed a loss of pulling power on my T25 1913cc petrol water cooled dg engine. (feels like it is running with ignition retarded) I have not been tinkering about. engine starts OK and ticks over roughly. there is no loss ...

Hi Covkid, when I last had the catch off, it was in clean condition, and no grease to speak of. As I mentioned in one of my previous posts, I'm wondering if the spring that pulls/holds the catch shut ,is worn or weak?? I think for the time being, I might experiment with moving that pin mounted on th...

Dare I ask how much?
and how long did it taks?
den

Thanks for that Billy, will just keep on experimenting and hope I get lucky, but in the meantime someone who has solved the catch problem may come on and enlighten us.

Hi Hotpod, over the years iv'e had my bus, I have read of loads of fellow T25 ownwers with this problem, but I dont know how they solved it. :roll: I am amazed that parts specialists like just kampers, don't stock this part, and also have no idea where it can be obtained, other than a scrappy. My wo...

hi all! my sliding door on my 1990 T25 is driving me mad. (keeps clicking open when travelling) have had it off and checked the mechanism and cleaned it etc. all looks well, and when refitted, the door clicks into place alright, and no amount of shaking causes it to pop open, BUT! just set off drivi...

Hi maxstu, ta for your comments.
never thought about it but yeah I guess everyone is away.
hopefully the kneck thing will be a bit better in a day or so, so's i can get on with the job.

den

anybody got a top tip on how to get to bolts holding the silence brackets on
( got a mega stiff kneck and wearing a collar at the moment so limitited at looking up the back end)
helpfull comments would be appreciated.
den

does anyone know if there is any concession on parts for being in the club,
eg just kampers etc
den

Hi everyone, my bus is a 1990 1.9 DG petrol engine. the silencer is up for renewal. the silencer fitted, has a boltded gas sealing ring flange to the left of the silencer, and on the other end is the tail pipe secured by a flange with a 3 holed gasket between. My Question is : :oops: Looking under t...

yeah! I'm busy writing at this very moment.
den