Search found 277 matches

by tommin
24 Aug 2015, 06:05
Forum: Electrical & Instrumentation
Topic: Interior fan only working on speed 1
Replies: 3
Views: 1349

Re: Interior fan only working on speed 1

Well there is not so bad news and there could be bad news for you.... If the fan is only working on number three speed then bad news could be your blower unit is just about to give in and go kaput, mine did the same. If you are getting a lower speed, possibly and this could be happen on number three...
by tommin
21 Aug 2015, 09:42
Forum: Mechanical
Topic: Offer of used engine 1.6D
Replies: 35
Views: 12556

Re: Offer of used engine 1.6D

Okay thanks for that information dave, but now I have a good motor in that is working and it just flew through its annual inspection no problems :D now it is on the market, I have purchased another van. Thanks to everyone for their input it truly was appreciated.
Regards
Tom
by tommin
15 Aug 2015, 13:26
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

Well that was a strange one, received the new blower today from Germany 26e plus 13e post, not bad! Tested it when I pulled old one out and as it should, it worked. Not only that but so did the control switch on all three settings. So even though new switch controller still in post from China at thi...
by tommin
09 Aug 2015, 14:45
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

Okay that makes sense. As for the fitting I have no issues making another hole in the dash for, if that is the easier route than disconnecting things from the board then refitting. I have opted for this one: http://www.ebay.co.uk/itm/20a-dc10-60v-pwm-hho-rc-universal-motor-speed-regulator-controller...
by tommin
09 Aug 2015, 09:55
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

What wattage do I need for the blower variable controller. I just found this on eBay rated to a max 400w
http://www.ebay.co.uk/itm/1Pcs-DC-12V-1 ... 4188c87691

Is this enough or is the 20amp needed for it???
Regards
Tom
by tommin
22 Jul 2015, 05:02
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

Thank you Covkid for taking the time and giving sound input/advice for me, much appreciated. I will no doubt be back to you regarding fitting that controller when I get it. Found a store here that has the blower unit for 56euro, not a bad price. It would though cost someone a small fortune if they g...
by tommin
21 Jul 2015, 15:26
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

:| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :| :( Did a test run up the road about 3 km got home put the fan on, a couple of minutes fan died am gutted :( :( :( :( :( :( :( :( :( :( :( :( :( :( Ghost you were right, it needs a new blower, no point trying to repair some...
by tommin
21 Jul 2015, 11:52
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

I stand corrected, fuse has been replaced with correct one. I read that due to the fan working only on full then I have to replace the resistor, any ideas on where from and what rating am I needing, I am out of my depth with resistors?
by tommin
21 Jul 2015, 10:07
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Re: Blower gone suddenly 1.6D

Temper temper ghost, like I stated it is only temp until I fix the unit, and as I write it is done. The blower unit is a must for de-misting, would be surprised an inspection would pass a vehicle without such measures? Anyhow I spent this morning first off wasting my time drilling a stupid hole in a...
by tommin
21 Jul 2015, 04:42
Forum: Electrical & Instrumentation
Topic: Blower gone suddenly 1.6D
Replies: 16
Views: 6388

Blower gone suddenly 1.6D

I checked out the wiki and read a few threads, thanks Covkid for some good info there. My symptoms were sudden, turned the engine on and the fan suddenly died????? Fuse blew, it is on a separate fuse link from wipers which confused me at first, as the wipers worked :shock: I replaced the fuse with a...
by tommin
12 Jul 2015, 05:58
Forum: Mechanical
Topic: Offer of used engine 1.6D
Replies: 35
Views: 12556

Re: Offer of used engine 1.6D

Throttle cable linkage sorted, had slight oil leak from dipstick tube, hopefully that too is now sorted. I have a question on what to do regarding the exhaust? I am not sure whether to try and use old box and find a way to wrap the down pipe under and back but am afraid it may sit to low, or run the...
by tommin
11 Jul 2015, 12:42
Forum: T25 Alternative Engine Forum
Topic: Finding TDC on 1 y
Replies: 4
Views: 1424

Re: Discrepancy on what is TDC on 1.9d ??

Rotate until you find the V on the clutch plate, this should then line up with the crank tdc etc...
by tommin
10 Jul 2015, 10:40
Forum: Mechanical
Topic: Offer of used engine 1.6D
Replies: 35
Views: 12556

Re: Offer of used engine 1.6D

:ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok :ok Who is a happy man today :D :D :D :D :D :D Me. Engine runs really nice, first turn of the key a few turnovers then that beautiful deep throaty roar. well the exhaust has yet to be sorted, but for now, it is enough it starts and runs swe...
by tommin
10 Jul 2015, 04:45
Forum: Mechanical
Topic: Offer of used engine 1.6D
Replies: 35
Views: 12556

Re: Offer of used engine 1.6D

Just a quick update: Engine is in (finally) todays will hook up ancillaries fluids etc.. and hopefully by the end of play will post the results. Info for those contemplating engine swaps, this is what I needed to change over: Water baffles side and front. Sump oil internal ductwork. Oil pan. Oil fil...
by tommin
07 Jul 2015, 04:51
Forum: Mechanical
Topic: Offer of used engine 1.6D
Replies: 35
Views: 12556

Re: Offer of used engine

Whilst I am waiting the spigot bearing, I decided to dismantle the turbo from the old engine, and what a freakin mess it is in. Thick oil and soot throughout, am not even going to bother with it any further, just happy decided not to Frankenstein it to the donor engine. :D A worthy note to all, chec...