Club 80-90 Forums

Thanks Rob.

Like adj the shoes on a Beetle throught the inspection/adj hole? I take it these would be on the rear/backing plate?

Cheers.

B

Hello again,

2.1 WBX Auto which type of fluid should be used in the auto transmission? Just bogo ATF4 or something more prefereable?

Also what is the final drive oil please.

Kind regards

B

Are all T25's the same when adjusting the handbrake travel, if so how is it done? (Still waiting for the manual in the post )

Many thanks

B

Hi there, I've been looking at a Caravelle with 2.1 WBX engine, auto with 99k on the clock, and there appears to be way too much oil in the engine as indicated on the dipstick. It appears to have been blowing back throught the breather tower and possibly into the air filter housing and contaminated ...

I'm flirting with the idea of buying a 7 seat Caravell and a concern is the 2 point lap straps fitted to all the rear seats as I have young shildren and their seats to in. Has any one else done the same or similar and encountered and problems or good fortune. Is there a conversion availble or is it ...

As the title says, are door locks and handles sided? The near side rear cab door handle and lock on my crew cab is knackered. Hit a bump in the road and the door pops open! Not good. The locking mechs and door handles look the same as the front pass & driver doors. But are they sided? Cheers. If...

same thing happened to me holiday, driving along and horn going off intermitently got some bad stares people wanted to fight me! Ne way, I took off the swheel and found sand (from the beach) had got in in between the two contact rings and tuned up one edge of the ring. Flattened it down cleaned up b...

I know this has been asked before what are the internal diameters of the fuel pipes that connect the main tank to the over flow tanks on either side?

Mine are all pershised!

ta

RHD 1.6 D

I've seen the wiki page on this! Do you realy have to drop the whole thing out the bottom or will just leaver come out the top after un bolting the coupling as I have good replacement to drop in?

Discuss.

when done post a reply
Im doing mine this weekend,

glow light on when cold
have to switch ign on and off to get to start properly

when warm no glow light
pain in the hoop to get started loads a smoke

when hot no glow light
starts no problem

my conlusion sensor and or sensor wiring

clutch shudder is the clutch plate slipping/not engaging correctly with the flywheel, or at worst the fly wheel is cracked or warped. 1st thing go for the cheap option have the system bled, and replace the old fluid with new. you said before you didn't have any leaks. it takes a small amount of air ...

sounds like the clutch isn't disengaging when depressing the pedal, could be the release bearing sticking/leaking and or your loosing fluid pressure or air in the system.

Have you got "shudder" when pulling away in 1st?

Worst of all your synchro rings are on the way out.

if if was low fuel pressure, ie bloked or contaminated fuel filter it wouldn't start period?

as stated b4 timing, and pump sorted v.quiet & smooth power highly reccmended money well spent!