Club 80-90 Forums

Gentlemen, Thank you both for that, Work recommences tomorrow. Rain and gales permitting
Ross

Firstly, pmoc-2001 and 1664 thank you for your replies, your help is appreciated. Am I right in saying that I have to run a double cable to the tap, one which will be an earth and the other a positive via a fuse, the positive then goes to the pump, which is earthed to the vehicle body. The tap has a...

Hello,
I,ve fitted my Snev sink and hob, Tanks are in. I've got a Comet single tap and a wee submersible pump, but not sure how to wire them up to the 12v system. I know that this is supposed to be simple. But !!! Can anyone put me back on track.
Thanks
Ross

Gentlemen,
thanks for your input, I have had a rethink and have decided to put the fresh inside.
Ross

Hello, I am fiting a water system to my RHD T25, and am looking for advice in fixing the tanks.The system will be a simple one tap affair, one 16 litre fresh tank and one waste tank of the same capacity. I want the tanks underneath, to save space, and I am considering Making a frame from aluminium a...

Hello, I've hit a snag in my rebuild, or should I say a first snag. I cannot get my Brand new and shiny Bluebird 3/4 width bed level in the bed postion. I don't know how far up the sloping bulkhead I need to drill for the bolts, or the postiion of the front support for the bed. Can anyone who has f...

Bluebird beds are designed for bays that have a higher engine bay. You have to build up a bed base at the rear. Mine is fitted so the back sits on the z shaped metal piece that comes with the bed for support then I made one using B&Q wood. I measured up exactly and got B&Q to chop the wood ...

Hi, I had a similar issue with mine, looking at the instructions it would seam that you have to have the horizontal part of the side frame horizontal, when in actual fact my brackets are about and inch or so below the top of the bulk head and sloping down considerably, and then the under seat frame...

Hello, I've hit a snag in my rebuild, or should I say a first snag. I cannot get my Brand new and shiny Bluebird 3/4 width bed level in the bed postion. I don't know how far up the sloping bulkhead I need to drill for the bolts, or the postiion of the front support for the bed. Can anyone who has fi...