Club 80-90 Forums

hi
is there a lot of travel in your handbrake i so it could be that your rear brakes may need adjusting
fairly easy to do
hope this helps

Tony

hi bamba you dont need to take needle off mate the hole in the midle is big enough to pass the needle through if you do take needle off to will need to gently lift needle over the stop pin and see where it settles and take note of its position i used a dinner fork to ease mine off but be very carefu...

i run my petrol eber on a deisel pump had no problem
it doesnt run quiet as warm as it should do as i think it allows less fuel through
thats probably due to diesel burns slower

Tony

IMO there not worth cutting the body work for they dont last long enough mate
try and find another way of making clearence
i cut valance on mine and regret it now

Tony

Try Volkspares for the rings
i had same problem
found them to be a lot cheaper
and top quality at the time

Tony

every time i go out in the T4 or the T25 i get a static shock off the body
any ideas

cheers Tony

hi shep
pop round tomorrow after work i'll have a look/listen for ya
gi me a bell

Tony

i think you will fin d its boss adapter on there
you will need a small pulling tool to take it off or a small blunt chisel and hammer
be careful not to damage the splines on the steering shaft

all the best Tony

all sorted
aiden was right nackered dizzy picked up broken one by mistake
now ive got to sort the lpg out

thankyou all for your help

cheers tony

im trying to get it running on petrol mark
every thing is set to the book i will sort gas out after ive sorted it on petrol
ive even checked the advance weights in dizzy
i will go through every thing again in the morning

Si did that pdf come in usefull mate

Hi covkid
triple checked everything
ive just replaced piston rings hydraulic lifters
and head gaskets its a 19 dg

an engine to run better with the timing advanced by 30 degrees
im struggling to get it to run at 5 before TDC
any ideas
cheers Tony

a bit of a broom handle works wonders Kev

I modded mine with a cordless drill motor
mine was a BL2
hope this helps

cheers