Club 80-90 Forums

I have the replacement part, when I find out how to post a pic I will  really just need confirmation on how to access it to cut and replace, I’m thinking from above I have to remove the floor edge above it im going to clean the paint off it see if I can locate the spot welds. thanks for all your rep...

Hi,
im about to replace the sill under the sliding door, the one with the bottom runner on for the door 
do I have to take off the floor panel above it to gain access? How is this fixed, I’m guessing it’s spot welded?
what do I have to look out for?
any tips would be greatly appreciated 
thanks

Hi,
Im going to take the top off my van as I've Boroscoped it  and found rust, not sure how bad it is, i guess ill find out.
How did you separate the hi top from the bodywork?
Did you find any panels or did you make them yourself?
Thanks

Any update on this as I have the same thing

Thanks guys, i got most of it, just the piezo igniter and water pump to figure

I'm trying to rewire my Autohomes Komet, I took pics when I took it all apart but can I find em now? nope. I'm looking at the 3 way electrolux fridge, the mains I left in so thats ok there's a big blak cable with a black and red wire comin from the relay beside the battery which I think goes to the ...

Yeah same thing only KAMEO instead of KOMET, vans looking smart too, nice one!

Just a normal EP2, or any grease you have to hand really. Its not high revs or load bearing

Do you think it would be an easy fix to change it to a Kameo?
I just rollered mine and it's a bit plain without the graphics
ta
Gil

Hi Gary, Guess what I have the same problem i.e. stud snapped off flush, how did "they" drill out in situ? one of these right angle drill adaptor thingies? mines on no. 1 cylinder, drivers side front if you like. any info would be greatly appreciated, I don't want to drop the engine if pos...

haha, chrystal balls lol,
1990, 1900cc dg
i have sorta just decided to drop the engine to drill out the studs

Hi Faggie,
Just to answer i cut it out, sorry to leave you hangin but i been away workin

Hi, The damned exhaust studs snapped taking the exhaust off. Do i really need to take the whole the engine out to remove the cylinder head to drill out the studs or is it possible to remove the head with the engine in? haynes says theoretically yes as long as the liner doesn't come out. whats the re...

Help!
how easy is it to remove / replace the rear window, can i do it or will i have to call the proffesionals?