Club 80-90 Forums

The top of the expansion pipes are not connected and should have 'Shrek ears' little valves on the free ends as per 'Sir Adventure's youtube replacement tank guide.

Don't walk away, 

BigBlueVan wrote: ↑05 Feb 2022, 18:21 Epoxy Mastic and seat boxes



Time for a beer.

Well deserved I would say, this is a very inspirational post and skilled work

another vote for the engine (number plate hatch)

and did the leak stop ( pinkies crossed)

The only time that I have had a breakdown and had to call the AA out was thanks to a Pertronix Flame thrower coil, was described as an all singing,all dancing, resin bonded american off road racing coil, maybe, but it didn't like English Classic trials and stranded me in the middle of Exmoor when tr...

Always good practice to replace all of the flywheel bolts as a precaution against failure :ok also if you have removed the flywheel to replace a leaking crankcase oil seal make sure that the flywheel does not have a grove worn into the contact surface with the oil seal ( see 'Itchfeets' post on fitt...

No worries

Re Allen key, I should have what you need to borrow

Look on the bright side, the stainless used on these tailpipes will not stay bright and shiney unless polished weekly, so you can save yourself the chore

Seems good price but the components would be less and also factor in running a HD supply wire from the battery otherwise you are only taking the load off the headlight switch not getting rid of the volt drop.

if the ring is 8mm then ebay 'bowden cable fittings' grub screw end comes up :ok  if not then try to drill the broken bit out and solder with blowtorch and using ' bakers fluid' flux, neutralise well after soldering with washing soda or corrosion will occur, I seem to remember ' bakers fluid' is hyd...

Or clean up the hole back to good metal and make it look as though it was meant to be there, provided you mean the floor of the bit below the air vent where the water drips and keeps you awake at night, kill two birds with one stone.

sure it's Garry at Autocrash 01424-892121 but don't make him too busy, he is due to paint my Audi 100 soonish when I have finished the rust treatment

The guy that I use is in Ninfield now was in Croydon, happy to recommend, he has replaced the lower front panel on mine and resprayed twice in the last 16 years ( every 7 years or so I remove all the glass and body fittings, sand, sand blast and treat the seams at home and he preps and sprays for me...