Club 80-90 Forums

I too have just fitted a replacement 2E3 to my Viking , took longer than expected to set up the idle settings but now all is fine. Flat spot gone and running smoothly again. Now for the MOT.
Must get around to sending the old one back sometime !

Passed MOT today , only 1 wiper blade needed !!!!!

60 mile round trip yesterday , think it may be cured . Thanks for the tips guys.

New distributor cap & rotor arm today , also had lid off the carb to adjust idle speed as still occasionally stalling. During this process & with engine running decided to loosen the pilot jet ...idle speed shot up then stalled. Removed jet and cleaned and replaced . On re - start idle highe...

HI, yes pipe is lower right side of engine and enables warm air from the exhaust area to a valve in front of the air box to assist in cold starts. Don't think it should melt tho as mine is of paper and expanded metal construction . Maybe the wrong type of pipe has been fitted ??

Had a good root around under the cover yesterday and discovered that the hot air intake pipe that connects to the exhaust system was dangling loose . After removing it found the inside had completely collapsed effectively blocking it, as this is controlled by a vacuum device possibly makes sense tha...

Hi Chaps , a problem with my T25 1.9 water cooled . About a month ago after idling at lights and pulling away the power dropped off and on stopping the idle dropped to almost a stall . At the same time the water level/temp light started flashing and the temp guage headed for the end stop just before...