Club 80-90 Forums

Cheers Aidan

Did that use a golf 3 release Bearing or was that still t3?

Hi, I've been running my afn with a hybrid clutch for long enough. I have now got a Tdi input shaft and I'm looking to fit Tdi clutch kit. Does anyone know which clutch kit is best? In sure I read somewhere that golf 3 Tdi was the one to go for but not 100%. Any help appreciated.

I am in Darlington and do a few spares and small repairs/service work if you get stuck. Cheers Jon

Is that a definite that they the same as a 1.9dj then? If so il E D I T my add in the for sale section it might help somebody out with a dg. I only listed it for a 2.1 Dj
Thanks

Breaking van for spares engine had it

I've just taken a Vw speed shop stainless steel exhaust system
Off a van, will it fit on a 1.9dg or are they different?

Anyone know any good conversion specialists that can supply 15mm knock on edgings. Had some samples from rainbow and I'm trying to match the original Westy Grey same as the door handles etc. Also emailed gunzle but had no reply as of yet http://i128.photobucket.com/albums/p191/gibletgibphil/image_zp...

Evening all! Can anybody suggest a supplier of decent rock and roll hinges to fit a T3? I have seen some on just pumpers sell some but it say to fit a T3 a raised platform has to be made on top of the engine hatch and I don't want to do that.

I'm sure I've seen some t3 westfalia interior drawings with all the measurements etc marked on them on here or another forum at some point. Does anyone know where I might find them?
CheersJon

Thanks for that, that's what I did with the pinto it had no dowels at all lol

Bit different I know but the pulleys off my mk2 escort engine (2.0 pinto) I had blasted and zinc plated, the cast is fairly pourus and the zinc finish went a bit blotchy after a short period of time, almost looked like it had gone mouldy. If they are pressed steel I would say yes if they are cast th...

Nice build you've got on the go here lloydy, should be pulling decent power without running issues when it's done. Just out of interest how much we're your new nozzles?

That's the inlet side of things sorted but what about the exhaust manifold side? Pd inlet with mod looks like a good setup

Is the pd manifold a direct fit to the afn head? Got access to a rig set so mod wouldn't take a lot of doing. Have u used afn turbo or pd unit or are they the same?