Club 80-90 Forums

with out sounding thick..how do i check that???

thanks again..

A systematic approach it the way to do it. It is possible if the dizzy has been stored and combined with a lack of lubrication throughout it's life the centrifugal advance has seized. The rotor arm shaft turns relative to the drive shaft when being centrifugally advanced. Remove the lubrication pad...

Sorry been away a while..

Have a similar problem, if i set the timing to 8deg its runs but has no rev range drives awful will not pull! if i move it round to about 20deg it goes a lot better!and will pull but has flat spots all over...

Any ideas?

SCHOOL BOY ERROR

Spent 5 mins last night swapping the wires about and she roars to life!

Toninght i will put it all back together and time it up jobs a gudun...

Thanks for all your help guys...

yep done that rotated in all direction quite a way too got nothing at all... really confusing!!

Could the dizzy drive gear be out as something does not seam right....can it be adjusted???

Hi, I fitted the dizzie and magic boxes as per the manual and nothing went bang or melted, but the van didn't start either I'll "talk" through what I did and hopefully someone a bit more knowledgeable will jump in and tell me what could be wrong? Firstly I popped of the dizzie cap. Then I...

Top man thank you....

I think its a plug and play jobbie!!

O.k...I have sourced a Distributor and control unit to replace the 090 thats fitted to my van (as i have been well informed its useless) i have 3 wires.. a brown with a spade connection that comes out at the Distributor end with black terminal, where does this go? Also i have a black and a green wir...

Steve p.m'ed ya dude..

cheers

For Bearings look up up your local Eriks Service Centre, Or let me know what is stamped on your bearing? i will get them dropped in to your local branch!. (And get you a good discount) I know on a bay it is 11749/11710 And 45449/45410 i think the t25 is the same if some one can confirm? What i will ...

doh!

Cheers ta...

if they are missing would it cause bad running and loss of power?

Does anyone know whay the bakerlite plastic peices do and if it has to be there between the Head and manifold on a 2ltr CU engine?
It standard solex carbs and mine are missing should they be there???