Club 80-90 Forums

On further investigation, I have traced the wiring back. The van was registered Apr 89, I'm guessing it did have an earlier engine fitted at some stage and the wire from what would have been the high pressure sender had been earthed. I am going to fit some new terminals, and connect the switches the...

I have done an engine swap DG for DG, my original engine only had the one oil pressure switch, the new one has the 2. The oil light and buzzer come on now just before 2000 revs. Am I right in thinking I need to alter some wiring to accommodate this extra switch?

That's interesting thanks for the heads up on that, I still haven't sorted the exhaust, so I will get in touch and see if they do just the silencer. Kevin. 

Thanks for your help, i will investigate further, but I probably won't rip it off and give it to you ! 

Looking at it now that was a branch reply, The system is JK J41207 T25 Stainless Steel Full Exhaust Kit
Slip on silencer, 45mm outside diameter

got in touch with longlife .. "Firstly, please let me take this opportunity to thank you for getting in touch with us regarding an exhaust for your VW Transporter T3.    Unfortunately due to the diameter needed for the exhaust were unable to carry out this work.     Sorry for any inconvenience,...

I would ideally want stainless, not too loud, trying not to upset the neighbours! i will check out the longlife suggestions though, thanks.

Hi there, i have acquired a replacement 1.9 wbx engine fitted with a JK stainless system, minus a silencer, just found out they don't sell the silencer separately :( . Its a push on, not a flange mount. The pipe is about 45mm dia, just wondering if any body has any ingenious ideas, motorcycle maybe?...

Just wondering if any body has used the brickwerks telescopic ones.

Can anyone advise/recommend the use of the telescopic replacement ones. thanks Kevin.

You are certainly right about them being busy, spoke to them today, booked up till March! but did give me some helpful advice as to what my problem might be.

I have breakdown cover, so should be OK.

cheers for that, just hope she doesn't let me down going up the A1!

Hi there, struggling to find any garages that I trust/are interested in looking at my panel, anybody got any recommendations in or around the Peterborough area. cheers Kevin.

The rears are in good condition, may have been replaced previously, the front one's are shot from the rack to behind the fuel tank. It seems cheaper to replace the whole lot with the brickwerks kit rather than individual front one's. thanks for your reply.