Club 80-90 Forums

Somebody was on Face Book vw t25 club asking the same question the other day and got a reply with that same pic saying where they got them from.

Sent from my SM-G920F using Tapatalk

Hi as the title says I need to clean my tank thats been sitting around for a couple of years. I'd appreciate any advice , ive tried blowing it out with a air line but there's still the odd cob web a little rust. I've been told that a hand full of small nuts and half a litre of petrol and give it all...

Lost spell checker at the end sorry.

Sent from my GT-N5110 using Tapatalk

I was also contemplating the same swap. I added up the cost of a good complete engine with all tinware and ancillaries plus the change of brake pedal set up with servo and a new gearbox. In the end I bought a mk3 golf gti with full service history and bad rust. Stripped it of all the bits needed for...

This guy was recomended to me by a couple of different resto firms. He did a first class job on mine.
Peter Englezos
Cogbox 0208842258.

Sent from my SM-G920F using Tapatalk

Hi guys do these grommets fit the expansion tanks as well or only the main tank.

Sent from my SM-G920F using Tapatalk

The conversion is gathering pace and going quite well at the moment but I've got a couple of questions. Do I need to put back the expansion tanks from the main fuel tank now I'm going EFI. Also the outlet on the side of the head I assume connects to one of the heating pipes that go to the matrix . D...

Aidan wrote:they are not unique to our cylinder so a trip to the scrappy may yield one from another vehicle, Mick at VW may have a van breaking or an old cylinder too

Cheers for that.

Sent from my SM-G920F using Tapatalk

Hi, like a div I've managed the snap the nipple of the bung that goes into the back of the master cylinder. Does anybody know where I can get a replacement bung or will have to replace the whole thing. I very tried all the normal outlets and the the repair packs don't include the bung. Cheers Orbit....

Hello there does anybody know of an alternative to partsbase.org as it seems to have been removed from the web.
Cheers .

Sent from my SM-G920F using Tapatalk

Hi I'm converting my air-cooled t25 to water cooled, I've installed the rad and all the necessary hoses that run front back. The problem I have, is I need to know exactly what hoses are needed in the engine bay and what they connect to. Any advice or part numbers appreciated. Cheers Orbit. Sent from...

Cheers ELVIS
I've sourced a diesel input shaft, but the guy has said It won't come with the locking sleeve and that the one on my petrol shaft will fit. Does this sound right.
Thank Dave.

Sent from my GT-N5110 using Tapatalk

I've been reading here and there about some people having to change their input shafts when doing the agg conversion . Could anybody please advise wether I also would need to change mine if so which one would I need.
Cheers Dave.
Sent from my SM-G920F using Tapatalk

Cheers Elvis your a star.

Sorry got bit a bit fat fingered then and hit send. What I'm asking is do I have to change the alternator bracket or is there some form of an extension that I can add to the housing to bring it out enough to pass over the bracket.