Club 80-90 Forums

A few years back i replaced my dead Electrolux with a Dometic RM 4181M....this is a little larger in depth but gave a very usable 40L cap. Till recently i've been living with it being visible having removed the original door, but now i've managed to get it far enough back to allow me to just about e...

Thanks Rich, i opened it up it looks good, but i'll give it a clean anyway.
Cheers

Incidentally has anyone tried to rejuvenate a mass flow sensor? A kind of last ditch attempt before buying a new one?

Hi I'm just fault finding a complete lack of power when under throttle and am left with the MAF sensor and the injectors to test. I'm testing the MAF as per manual and the resistances mentioned there are fine (ie temp sensor and what i assume to be base resistance). However when looking at pins 3 &a...

I had similar issues with my 1.9 GW, trouble is there are so many potential causes that it's a matter of elimination....after going through the usual culprits as you've mentioned, fuel lines, filters, pumps, vaccum hosese, ignition system etc etc....I took it to Phil Davies in Stonehouse, Plymouth. ...

I fitted an nlavw bunk a week ago, i was a bit dubious as to how comfy it would be, but the two wee yins (6 & 4) were fighting over it to sleep in it, both found it very comfy and the extra width over the other variety is definitely the way to go. I would not expect the holes to cause any weaken...

I replaced mine 5 days ago, the day before going on hols, not the best timing....but if you take your time it's not a difficult job. The best advice i'd give is soak all the nuts and bolts in WD40 or silicone lubricant for at least a day before you start the job, keep them wet with the lube and hope...