Club 80-90 Forums

I think the ones I got were 5mm window and 3mm panel.

They will help you

http://www.sealsdirect.co.uk/bbCMS/shop ... rtmentId=4

The products I bought were WR63, F572 and GT75

Not guaranteeing they would be right for you, but seemed to do the job (wrinkles apart)

i know, its amazing how easy and quick it is to get them out

I have refitted the rubbers on my side windows - all looks fine but I am left with big wrinkles on the inside rubber on the corners.

Do I have to glue them to the window

Whatever you do, don't leave it for a couple of years like I did. ended up taking most of the panel out when I grinded it. Now on my second window and quite enjoying it, and not too bad for an office boy whose never been under a bonnet. I would take the rubbers out etc and properly grind the rust do...

definately white then -yours is much darker.

Autosleeper's response was

"Pastel White and the code is L90D"

Is that Woolies as in pick and mix - should just go for the roller job all over!

Too much to take on with the rust that needs sorting. Just taken my rear side window out and practically no panel left around it.

1985 - cheers for your interest.

I got a mail back from autosleeper with an answer a short while ago. Wasn't sure that they would bother.

Does anyone know the spec of the autosleeper cream/biege paint for some much needed rust fighting

Cheers for that

Bit of a rust novice.

Have acquired Eastwoods Rust Disolver as recommended on the wiki.

Any tips on getting windows in and out an dealing with the rust?

Thanks Phil

Its a 1900 w/c petrol 1985

Hi there

Any tips/advice on replacing my fuel pipe from the fuel filter through to the pump.

(What diameter pipe do I need/which end do I start from???)

Appreciate any help.

Cheers

Anything to do with carbs is a bit scary to me, but I'll have a go at replacing the fuel filter.

Thanks for the advice

Thanks